Jump to content

Water pump pipe to heater hose


Recommended Posts

On my 4A the original mild steel pipe rusted through some ten years ago, as most will have done by now I guess. I replaced with a stainless steel version from Phoenix (the exhaust people). It needed a little bit of fettling to achieve a good fit but no real problem,

 

Tim

Link to post
Share on other sites

Hi Rich,

the 4/4A has the pipe running form the front, then around the back of the engine to the bulkhead rubber pipes

 

The TR2/3/3A doesn;t

 

Roger

...and of course the 6 cyl one (214404 & 201405) is longer with the same tube diameter and uses same olive and threaded end fitting. The TR250/6 carb version (214405) has two outlets at the bulkhead end.

Spitfire/GT6 etc uses same sized tube diameter too.

Tube is 1/2" od. NOT metric.

 

Peter W

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.