DaveN Posted February 22, 2018 Report Share Posted February 22, 2018 CR chassis. New Radiator bottom hose is tight up against the cross member. Now the bottom hose boss/pipe on the Radiator does have a slight bend as is correct but should it also be bent downwards allowing the hose to sweep up and thus clear the chassis? Its almost as if the rad brackets should be slightly higher (therefore allowing the rad to sit lower). The downside to this would mean the two stays would have to be altered otherwise due to triangulation the rad would not be vertical! Another minor point theres no way in its current configuration would the rubber isolation washers fit.! Thoughts anyone? Dave Quote Link to post Share on other sites
elclem1 Posted February 22, 2018 Report Share Posted February 22, 2018 Double sided tape is thinner and does the same job would that work? Quote Link to post Share on other sites
lee Posted February 22, 2018 Report Share Posted February 22, 2018 On this topic (as just fitted my rad without that issue) my top hose is much too big on internal diameter Is there a smaller bore available? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.