iain Posted January 23, 2017 Report Share Posted January 23, 2017 Hi Sage ones What is the standard construction for 4 pot pushrods? I ask, as Bob (Lebro) mentioned that in his they where solid rods with integral ends. Did they change through production to hollow tube with fitted head and tail ends? Cheers Iain Quote Link to post Share on other sites
Motorsport Mickey Posted January 23, 2017 Report Share Posted January 23, 2017 As far as I know they were ALWAYS tube construction with pressed in ends, they are good quality. Mick Richards Quote Link to post Share on other sites
Don H. Posted January 23, 2017 Report Share Posted January 23, 2017 Bob has a "different" engine from most of us. A FRE (factory reconditioned engine) at some point in its mid-life of late 60s or so. Quote Link to post Share on other sites
BlueTR3A-5EKT Posted January 23, 2017 Report Share Posted January 23, 2017 They started life as solid then went to tubes with pushed in ends - at engine No TS 12961 E Peter W Quote Link to post Share on other sites
iain Posted January 23, 2017 Author Report Share Posted January 23, 2017 Cheers guys, that's that sorted. Iain Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.