cp7535he Posted January 9, 2017 Report Share Posted January 9, 2017 (edited) doing my tr6 dash gauges, looked at some of the forum tips Nisonger ,USA do flat bezel gauge seals ~Bezel Gasket gasket sets , 2 x 125mm & 4 x 52mm Gauges I have a small length of , round cross section 'rubber' cord seal but wonder if anyone knows if there is a UK supplier of the flat seals. Any tips on restting the bezel to the gauge body ~ tapp the tabs, or just twist it on ? cheers robin Gtwr Edited January 9, 2017 by cp7535he Quote Link to post Share on other sites
RogerH Posted January 9, 2017 Report Share Posted January 9, 2017 Hi Robin, there are a few suppliers on ebay. I'll have a look at the name on my box in the garage in a few minutes. The bezel should just twist on/off. However old seals can become sticky. Roger Quote Link to post Share on other sites
DaveN Posted January 9, 2017 Report Share Posted January 9, 2017 Is this what you need? http://www.autoelectricalspares.co.uk/010181-new-2-square-section-rubber-ring--seal-for-smiths-jaeger-gauges-1316-p.asp The original 'seal' was a supposedly non setting mastic........that sets! The bezels are available too but I laid mine face down and wetted the joint with some petrol, a few days later they separated without too much fuss. Quote Link to post Share on other sites
cp7535he Posted January 10, 2017 Author Report Share Posted January 10, 2017 found and decided to use JDO website as they offer a sponge gasket that will fit between the glass under the bezel www.jdo1.com [a lot cheaper than usa Nisonger] so end of search thanks everyone Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.