Jump to content

Correct Choke Cable Run


Recommended Posts

On 1/13/2022 at 3:24 PM, RogerH said:

Hi David,

 obviously the lack of the half moon wedge plate is the cause of the cale not staying out.

The half moon plate would certainly generate some brass filings but as it is not there then !!!!!!

Does the rear carb not have any possibility of holding the choke cable - your set-up doesn't look right.  Any chance of a Photo from above showing both carbs.

 

Roger

So to follow up on this saga, I discovered that the black circular springy clip on the choke barrel behind the dash had slipped off during several different cable routing attempts, clearly this allowed the half moon locking segment to fall out. I hadn't realised just how tiny the half moon piece was - really small!  I shall have a go at making a replacement from a bit of hacksaw blade as suggested, first few attempts the blade snapped into bits when I put it on the grinding wheel - perseverance!

David

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
×
×
  • Create New...

Important Information

Please familiarise yourself with our Terms and Conditions. By using this site, you agree to the following: Terms of Use.