HeswallTR3 Posted January 3, 2014 Report Share Posted January 3, 2014 Hi My fuel gauge has never been quick on the uptake (usually took a few minutes to register whats in the tank) I noticed the other day that it has now given up and is registering zero......the tank is actually half full. Any simple hints and tips before I need to take more drastic action Thanks in advance Keith Quote Link to post Share on other sites
stuart Posted January 3, 2014 Report Share Posted January 3, 2014 (edited) Obviously check your wiring especially the earth on the sender first. Disconnect the wires at the sender and then check with a meter that the sender is doing something with a meter across the terminals on resistance setting whilst raising and lowering the float and also that you have voltage at the sender green and black wire. Also check the wires at the gauge that you have 12 volts in at the green and out at the green and black. Then tell us what you have. Stuart. Edited January 3, 2014 by stuart Quote Link to post Share on other sites
HeswallTR3 Posted January 3, 2014 Author Report Share Posted January 3, 2014 Thanks..will check it over the weekend Keith Quote Link to post Share on other sites
BrianC Posted January 3, 2014 Report Share Posted January 3, 2014 Is the float floating? Check that it's not partially or completed submerged due to a leak. Although these gauges usually take a minute or two to give a sensible reading, if it was very slow to come up to a correct reading before, then it's quite likely the float was leaking slightly and has just got much worse. Try hooking the arm up to see if the reading changes. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.