Dave_163 Posted March 21, 2017 Report Share Posted March 21, 2017 Any opinion on the pattern? Backlash between 0,004" and 0,006" as in manual. Thanks in advance. David Quote Link to post Share on other sites
mjdearing Posted March 22, 2017 Report Share Posted March 22, 2017 Hi Dave,first two photo's show low and inward mesh which is good however the last two shows the mesh higher and outward,i would be concerned that under load the mesh might actually reach the edge (under load mesh moves outwards and upwards) if the axle is rebuilt than i would be a bit concerned but if its not been touched then i would go with it. Im no expert but have done a few axles and all i can say is its very challenging to get the mesh bang on,but if you dont , problems down the road for sure. Haynes Triumph 2000/2500 manual has the best section on axles ? Martin Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.