fisicx Posted May 27, 2015 Report Share Posted May 27, 2015 Everything came apart OK but the pushrod now sticks out too far and I can't install the slave cylinder. There's about an inch gap between the mating faces. I can move the pushrod back and forth but there isn't a lot of travel and when I push it into the cluch housing it appears to jam. So that's where I think the problem is. The push rod is free to move in the clip but it doesn't feel as if it's fully engaged on the clutch arm. I can't move the clip and have no idea if it's supposed to move. Any suggestions would be most welcome. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.