rdornbach Posted January 19, 2015 Report Share Posted January 19, 2015 (edited) I am rebuilding my engine out of my TR4A. I am disassembling and ran into the extension fan hub not wanting to release from the fan hub. It appears that the extension fan hub is rusted to the fan hub pulley? This is not the original engine the car came with. My hub extension is solid with a square peg where the plastic fan mounts. Edited January 19, 2015 by rdornbach Quote Link to post Share on other sites
graeme Posted January 19, 2015 Report Share Posted January 19, 2015 Hi and welcome to the TR Forum. Have you removed the large bolt through the extension that holds the assembly to the crank? Assuming you have, then plenty of penetrating oil and gently tapping sideways on the extension while holding the hub in a vice or similar. Cheers Graeme Quote Link to post Share on other sites
rdornbach Posted January 20, 2015 Author Report Share Posted January 20, 2015 A good pair of reading glasses solved the big center bolt issue. All good Quote Link to post Share on other sites
Guest Posted January 20, 2015 Report Share Posted January 20, 2015 Two posts, so a very warm welcome here! (Since you're from Minnesota, I think you can use some warmth ) Please show us some pics of the job you're tackling. For posting a large amount of pics, it is best to use a Photobucket, Flickr or Picasa account. Menno Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.