ronhatch Posted October 23, 2014 Report Share Posted October 23, 2014 Hi all, I am currently engaged in bodywork but every so often I like to take a break and do something different from welding filling sanding etc. and this time I decided to renovate the number plates. I have the plates with the raised ally numbers so I drilled off the numbers and cleaned them and silver painted them, they look great. I stripped the ally plates and under coated them but got a reaction (bubbles in the finish) so I stripped them and this time used an etch primer, same problem. I am using black celly and I assume this is reacting with the ally but I thought the etch primer would seal it. Any help would be appreciated as a mental diversion is driving me nuts ! Quote Link to post Share on other sites
Geko Posted October 23, 2014 Report Share Posted October 23, 2014 (edited) Modern primer in tins does not dry properly unless you keep the plates near a source of heat for a couple of hours. Bubbles are likely to be condensation. For the ally numbers: polish then clear gloss retains the original look and is likely to save you some speeding tickets. Edited October 23, 2014 by Geko Quote Link to post Share on other sites
ronhatch Posted October 24, 2014 Author Report Share Posted October 24, 2014 Thanks for the reply.Unfortunately there was not much paint left on the plates hence the repaint, conditions were dry and warm. Quote Link to post Share on other sites
BrianC Posted October 24, 2014 Report Share Posted October 24, 2014 (edited) I have just painted a pressed aluminium and an original Ace plate with raised letters following Forum advice (http://www.tr-register.co.uk/forums/index.php?/topic/48185-repainting-pressed-aluminium-number-plates/?hl=paint). I used Halfords satin black spray followed by some old clearcote left over from my MG Metro on both and had no reaction. Edited October 24, 2014 by BrianC Quote Link to post Share on other sites
Fireman049 Posted October 24, 2014 Report Share Posted October 24, 2014 For pressed aluminium plates I'd coat the raised digits with liquid Latex and when that's cured I'd spray the plates with Halfords gloss black paint. Remove the latex coating and polish the digits. It worked fine for me. Tom. Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.