AL TR250 Posted September 14, 2014 Report Share Posted September 14, 2014 Finally repatriated my new TR250 and am trying to get it ready for MOT. Having lived most of its life in California, it seems that washing the windscreen isn't a priority over there. Unfortunately it is for an MOT! Apart from the pump being knackered, there is no tubing from the bottle to the T piece in the plenum. I presume the tube goes from the bottle through the grommet into the footwell but how does it then get into the plenum? The only way that I can see is next to the rod that opens and closes the flap. Is that right or should there be another way in? Thanks Ali Quote Link to post Share on other sites
brenda Posted September 15, 2014 Report Share Posted September 15, 2014 That's how it is on my 4a. Mike biddulph redrose group. Quote Link to post Share on other sites
AL TR250 Posted September 15, 2014 Author Report Share Posted September 15, 2014 Thanks Mike. Back to lying down, head under the dash. Quote Link to post Share on other sites
harrytr5 Posted September 17, 2014 Report Share Posted September 17, 2014 If memory serves me right,there is a hole just left of the heater box.This is directly underneath the windscreen scuttle.Use the right grommet of course. Regards Harry. Quote Link to post Share on other sites
Phil Horsley Posted September 17, 2014 Report Share Posted September 17, 2014 Spot on Harry, that's where it is having just done mine during rebuild Quote Link to post Share on other sites
AL TR250 Posted September 18, 2014 Author Report Share Posted September 18, 2014 Thanks guys. I will have a look. Quote Link to post Share on other sites
brenda Posted September 18, 2014 Report Share Posted September 18, 2014 I will also have a look again could not find a hole when I was under my dash. Mike Biddulph red rose group. Quote Link to post Share on other sites
graeme Posted September 18, 2014 Report Share Posted September 18, 2014 Pic of the correct location on a TR6. I am sure that it is the same on a TR250. Cheers Graeme Quote Link to post Share on other sites
AL TR250 Posted September 20, 2014 Author Report Share Posted September 20, 2014 Thanks Graeme. Your photo was spot on. Everything was covered in sound deadening but when I gave it a poke with the screwdriver it went right through. All set for the MOT now. Ali p.s. does anyone know if it's possible to repair the old Lucas washer pump? Quote Link to post Share on other sites
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.